Description
The SBC-5926 is designed to address to the issues of wide swing of output voltages from the smart alternator, start & stop, braking regenerative EURO 5/6 vehicles in fully charging the house batter y. It is suitable for use with all old alternator system and distant house battery.
There are 3 alternator charging modes available, Factory Preset Mode, Ignition Feed Mode and Vibration Sensor Mode.
The built-in vibration sensor makes it possible to use the charger by just connecting to the starter battery terminal without touching the car's electrical/ electronic wiring thus avoiding any possible excuse of revoking the car's warranty.
The digital control and auto-select design of SBC-5926 make it automatically adapt to 12V or 24V input alternator/ battery system.
This is an automatic dual input solar & alternator-battery charger for charging 12V house battery banks of lead acid, AGM type II and Lithium Fe Po4 batteries.
The built in Solar charge controller is of Maximum Power Point Tracking (MPPT) technology which maximizes the PV power from your 12V solar panels to your house battery.
In 12V alternator/ battery system, the house battery is charged by both Solar and alternator/ battery simultaneously to maximize the free solar energy .
**In 24V alternator/ battery system the house battery is charged by Solar only when the car's alternator/ battery stops charging operation.
This is a select (battery type) and forget charger designed for fast and accurate recharge of your deep cycle house battery.
The smart multi-stage charging enables the charger to be connected permanently to your battery banks without the worry of over charging or drying out the electrolyte.
Lead Acid Based Battery
A 3 Stage Bulk, Absorption & Float charging profile with maximum constant charging current at the Bulk Stage and a Constant Voltage with decreasing charging at the Absorption Stage and a reduced voltage Float Charge for maintenance when battery is full.
LiFePO4 (LFP) Battery
A 2 Stage charging is specially for the LiFePO4 battery and charging current stops at the end of Absorption Stage.
There are 3 alternator charging modes available, Factory Preset Mode, Ignition Feed Mode and Vibration Sensor Mode.
The built-in vibration sensor makes it possible to use the charger by just connecting to the starter battery terminal without touching the car's electrical/ electronic wiring thus avoiding any possible excuse of revoking the car's warranty.
The digital control and auto-select design of SBC-5926 make it automatically adapt to 12V or 24V input alternator/ battery system.
This is an automatic dual input solar & alternator-battery charger for charging 12V house battery banks of lead acid, AGM type II and Lithium Fe Po4 batteries.
The built in Solar charge controller is of Maximum Power Point Tracking (MPPT) technology which maximizes the PV power from your 12V solar panels to your house battery.
In 12V alternator/ battery system, the house battery is charged by both Solar and alternator/ battery simultaneously to maximize the free solar energy .
**In 24V alternator/ battery system the house battery is charged by Solar only when the car's alternator/ battery stops charging operation.
This is a select (battery type) and forget charger designed for fast and accurate recharge of your deep cycle house battery.
The smart multi-stage charging enables the charger to be connected permanently to your battery banks without the worry of over charging or drying out the electrolyte.
Lead Acid Based Battery
A 3 Stage Bulk, Absorption & Float charging profile with maximum constant charging current at the Bulk Stage and a Constant Voltage with decreasing charging at the Absorption Stage and a reduced voltage Float Charge for maintenance when battery is full.
LiFePO4 (LFP) Battery
A 2 Stage charging is specially for the LiFePO4 battery and charging current stops at the end of Absorption Stage.
- Dual Input from car battery with alternator and Solar panel.
- Auto select for 12V or 24V car system
- Design all alternators, conventional and smart alternators.
- 3 DC Charge Modes to select :
- Vibration Sensor Mode
- Ignition Feed Mode with Automatic or Manual Control setting.
- Factory Preset Mode ( charging function always on )
- Suitable for Lead Acid, AGM, and LiFePO4 battery.
- Protections:
- Self Recoverable Input Under Voltage Protection.
- Self Recoverable Output Over Voltage Protection.
- Self Recoverable Over Temperature Protection.
- Self Recoverable Over Load Protection (C.C.) with constant current at decreased output voltage.
- Self Recoverable Input Reverse Polarity Protection.
- Output Reverse Polarity Protection by thermal fuse.
- Auto select for 12V or 24V car system
- Bluetooth version charger allows for remote monitoring of charging status of battery on smartphones by using apps. The apps can be downloaded from App store or Google Play.
